Currently, composite resins have become the material of choice for the restoration of posterior teeth. Although bulk-fill resins represent a tempting alternative due to their lower complexity and faster use, some dentists are reluctant to use this material. The objective is to compare the performance of bulk-fill resins and conventional resins in direct restorations of posterior teeth based on the literature. T...
(1) Background: Coronal microleakage can lead to endodontic treatment failure. This study aimed to compare the sealing ability of different temporary restorative materials used during endodontic treatment. (2) Methods: Eighty sheep incisors were collected, uniformized in length, and access cavities were performed, except for in the negative control group, where the teeth were left intact. The teeth were divided...
This study aimed to evaluate and compare the microleakage of composite resin restorations under a total-etch adhesive system applied with two different techniques, with and without cure. Cavities were made on the buccal surface of twenty-six intact teeth and subsequently restored with bulk-fill flow composite resin (SDR®® flow+) and conventional resin (Spectra™ ST HV). Two experimental groups were created, one ...
Direct pulp capping consists of a procedure in which a material is directly placed over the exposed pulp to maintain dental vitality. Although still widely used in clinical practice, previous in vitro studies found that the biomaterial Life® presented high cytotoxicity, leading to cell death. This study aimed to identify the Life® constituents responsible for its cytotoxic effects on odontoblast-like cells (MDP...
Despite developments and advances in dental materials which allow for greater restorative performance, there are still challenges and questions regarding the formulation of new compositions and chemical reactions of materials used in restorative dentistry. The aim of this study was to assess and compare the mechanical and tribological characteristics of a bioactive resin, a composite resin, and a glass ionomer....
The surface smoothness of composite restorations affects not only their esthetic appearance but also other properties. Thus, rough surfaces can lead to staining, plaque accumulation, gingival irritation, recurrent caries, abrasiveness, wear kinetics, and tactile perception by the patient. The aim of this study was to evaluate the influence of irrigation during the finishing and polishing of composite resin rest...
The aim of this study was to determine the effect of acidic beverages on the mechanical characteristics of a nanofilled composite resin and of a glass ionomer. Thirty specimens of each restorative material were produced and were evaluated at three different time points: before immersion (T0), after a 7 day immersion (T1) and after a 14 day immersion (T2) in water, beer and a soft drink. The studied parameters w...
Pre-eruptive enamel lesions occur during tooth formation and include fluorosis, traumatic hypomineralization, and molar incisor hypomineralization. Minimally invasive treatment approaches, such as microabrasion, should be considered for these cases. This article presents a case series of three patients with pre-eruptive enamel defects in esthetically compromised tooth regions which were treated with the microab...
Some authors have been proposing the use of cavity disinfectants in order to reduce, or even eliminate, the effect of the microorganisms present in a dental cavity before a restoration is placed. The aim of this study was to evaluate the effect of different cavity disinfectants on bond strength and clinical success of composite and glass ionomer restorations on primary teeth. The research was conducted using Co...
This study aimed to assess the cytotoxicity of commercially available adhesive strategies-etch-and-rinse (Adper™ Scotchbond™ 1 XT, 3M ESPE, St. Paul, MN, USA, SB1), self-etch (Clearfil™ SE Bond 2, Kuraray Noritake Dental Inc., Tokyo, Japan, CSE), and universal (Scotchbond™ Universal, 3M Deutschland GmbH, Neuss, Germany, SBU). MDPC-23 cells were exposed to adhesives extracts in different concentrations and expos...