During machining processes, a high temperature is generated in the cutting zone due to deformation of the material and friction of the chip along the surface of the tool. This high temperature has a detrimental effect on the cutting tool, and for this reason, it is of the utmost importance to assess the cutting temperature in real time during these processes. Despite all the advances and investigation in this f...
Objetivos: O objetivo deste estudo consistiu em comparar o torque máximo entre dois sistemas dinâmicos (BHS30® e UBH30® de 4 estrias) e caracterizar as falhas dos seus componentes (chaves de aperto e/ou parafusos). Materiais e métodos: De forma a testar o comportamento mecânico de dois sistemas dinâmicos, foi realizado um estudo experimental laboratorial. Três amostras de cada sistema foram submetidas a um torq...
In the last decade, it has been common to observe a competition between coatings achieved via physical vapor deposition (PVD) and chemical vapor deposition (CVD) techniques on cutting tools used in machining processes. The tool’s substrate material can immediately condition the coating process selection. However, there are also materials capabe of adapting to any of the coating processes. Hence, the capabilitie...
Pelo inter-relacionamento de três conceitos - globalização dos mercados, integração europeia e soberania nacional -, e consequentes efeitos, o artigo procura fazer-nos compreender a complexa realidade dos tempos de viragem do século, baseando-se em duas razões: o facto de os referidos conceitos constituirem expressões de elementos fundamentais (tecnológico-económico, resposta estratégica às condições da vida in...