Publicação
Comparative study of vibration measuring techniques applied to Aluminum beams with localized damage
| Resumo: | When a structural damage changes the characteristics of stiffness and mass of a mechanical system, the dynamic behavior of this beam will also change. Only a few studies about the correlation between damage and the effect caused in dynamic behavior can be found. Based on this, this study will analyze the behavior of the natural frequencies and damping ratios of four aluminum beams, with and without damages. This work aims to determine the error between the two methods of data acquisition and the effects of the damage inflicted on the shape modes, natural frequencies and damping ratios for each beam. To achieve the purposes, initially, a numerical FEM simulation will be performed, followed by experimental impact tests, aiming to obtain the estimated natural frequencies and damping ratios. After this, damages will be made on these beams and the impact tests will be repeated for each beam. The FEM analysis will be performed using Ansys. For the impact tests, two data acquirement methods will be used during the impact testing, the first, using accelerometers to obtain the vibration response, the second using a Brüel & Kjær’s sound level meter. The obtained data will be compared and will be possible to determinate the error between the natural frequencies measured using both methods. The results obtained will be used to correlates the dynamic behavior with the damages inflicted on the beams. This paper allowed analyzing the usage viability of the sound level meter to measure the output of a vibrating system, considering certain limitations. In addition, the damage effects on the natural frequencies of the beams. |
|---|---|
| Autores principais: | Silva, Edson Vinicius Garcia |
| Assunto: | Aluminum beams |
| Ano: | 2020 |
| País: | Portugal |
| Tipo de documento: | dissertação de mestrado |
| Tipo de acesso: | acesso aberto |
| Instituição associada: | Instituto Politécnico de Bragança |
| Idioma: | inglês |
| Origem: | Biblioteca Digital do IPB |
Registos relacionados
article Comparative study of vibration measuring techniques applied to aluminum beams localized damage
por: Silva, Edson Vinicius Garcia
Publicado em: (2019)
por: Silva, Edson Vinicius Garcia
Publicado em: (2019)
article On the thermodynamics of aluminum cladding oxidation: water as the catalyst for spontaneous combustion
por: Maguire, John F.
Publicado em: (2022)
por: Maguire, John F.
Publicado em: (2022)
article Vibration damping and acoustic behavior of PU-filled non-stochastic aluminum cellular solids
por: Carneiro, Vítor Hugo Pimenta
Publicado em: (2021)
por: Carneiro, Vítor Hugo Pimenta
Publicado em: (2021)
article Ultrasonic vibration as a primary mixing tool in accelerating aluminum–copper alloys preparation from their pure elements
por: Muhrat, Abdulsalam
Publicado em: (2019)
por: Muhrat, Abdulsalam
Publicado em: (2019)
article Aluminum recovery from water treatment sludges
por: Boaventura, Rui A. Rocha
Publicado em: (2000)
por: Boaventura, Rui A. Rocha
Publicado em: (2000)
article Water and oil wettability of anodized 6016 aluminum alloy surface
por: Rodrigues, S. P.
Publicado em: (2017)
por: Rodrigues, S. P.
Publicado em: (2017)
article Aluminum-to-steel cladding by explosive welding
por: Carvalho, Gustavo
Publicado em: (2020)
por: Carvalho, Gustavo
Publicado em: (2020)
category Invasive neural electrodes structure fabrication based on aluminum wafers
por: Peixoto, A. C.
Publicado em: (2012)
por: Peixoto, A. C.
Publicado em: (2012)
article A new approach to ultrasonic degassing to improve the mechanical properties of aluminum alloys
por: Puga, Hélder
Publicado em: (2014)
por: Puga, Hélder
Publicado em: (2014)
article Automation of beam straightness measurement
por: Ribeiro, A. Fernando
Publicado em: (1994)
por: Ribeiro, A. Fernando
Publicado em: (1994)
article Welding process automation of aluminum alloys for the transport industry: an industrial robotics approach
por: Ribeiro, J.E.
Publicado em: (2021)
por: Ribeiro, J.E.
Publicado em: (2021)
article Determination of aluminum (III) in crystallized fruit samples using a multicommutated flow system
por: Tóth, Ildikó V.
Publicado em: (2004)
por: Tóth, Ildikó V.
Publicado em: (2004)
article Neural electrode array based on aluminum: fabrication and characterization
por: Peixoto, Alexandre Coumiotis Moreira
Publicado em: (2013)
por: Peixoto, Alexandre Coumiotis Moreira
Publicado em: (2013)
article Automation of beam straightness measurement with image processing tools
por: Ribeiro, A. Fernando
Publicado em: (1996)
por: Ribeiro, A. Fernando
Publicado em: (1996)
article Friction stir welding and explosive welding of aluminum/copper: process analysis
por: Carvalho, G. H. S. F. L.
Publicado em: (2019)
por: Carvalho, G. H. S. F. L.
Publicado em: (2019)
article Thermodynamics of tower-block infernos: effects of water on aluminum fires
por: Maguire, John F.
Publicado em: (2019)
por: Maguire, John F.
Publicado em: (2019)
article Surface atomic arrangement of aluminum ultra-thin layers grown on Si(111)
por: Jum’h, Inshad
Publicado em: (2023)
por: Jum’h, Inshad
Publicado em: (2023)
article Microshaping of aluminum-based neural microelectrode arrays using chemical wet-etching
por: Gonçalves, Sandra Beatriz Tomé
Publicado em: (2014)
por: Gonçalves, Sandra Beatriz Tomé
Publicado em: (2014)
article Modelling and simulation of Fe2O3/aluminum thermite combustion: experimental validation
por: Durães, Luísa
Publicado em: (2006)
por: Durães, Luísa
Publicado em: (2006)
article An experimental and numerical study on aluminum alloy tailor heat treated blanks
por: Pereira, Rui
Publicado em: (2023)
por: Pereira, Rui
Publicado em: (2023)
groups Single side damage simulations and detection in beam-like structures
por: Zhou, Yun-Lai
Publicado em: (2015)
por: Zhou, Yun-Lai
Publicado em: (2015)
rate_review Vibration modes of the Euler–Bernoulli beam equation with singularities
por: Dias, C. Nuno
Publicado em: (2024)
por: Dias, C. Nuno
Publicado em: (2024)
article Experimental and numerical study to minimize the residual stresses in welding of 6082-T6 aluminum alloy
por: Costa, Sharlane
Publicado em: (2021)
por: Costa, Sharlane
Publicado em: (2021)
article Physiological responses of Plantago algarbiensis and P. almogravensis shoots and plantlets to low pH and aluminum stress
por: Martins, Neusa
Publicado em: (2013)
por: Martins, Neusa
Publicado em: (2013)
article Interferometric techniques in structural damage identification
por: Lopes, Hernani
Publicado em: (2011)
por: Lopes, Hernani
Publicado em: (2011)
article Optimization of robotized welding in aluminum alloys with pulsed transfer mode using the Taguchi method
por: Izeda, António Eduardo Cruz
Publicado em: (2018)
por: Izeda, António Eduardo Cruz
Publicado em: (2018)
article Damage identification based on vibration measurements applied to masonry structures
por: Ramos, Luís F.
Publicado em: (2006)
por: Ramos, Luís F.
Publicado em: (2006)
article Interferometric techniques in structural damage identification
por: Lopes, Hernani
Publicado em: (2012)
por: Lopes, Hernani
Publicado em: (2012)
article Nugget formation and mechanical behaviour of friction stir welds of three dissimilar aluminum alloys
por: Neves, Manuel
Publicado em: (2020)
por: Neves, Manuel
Publicado em: (2020)
article Nugget formation and mechanical behaviour of friction stir welds of three dissimilar aluminum alloys
por: Manuel, Neves
Publicado em: (2020)
por: Manuel, Neves
Publicado em: (2020)
article Localization of damage in beams using interferometric techniques
por: Lopes, Hernani
Publicado em: (2012)
por: Lopes, Hernani
Publicado em: (2012)
article Robotic welding tests MIG standard and CMT+P in aluminum alloy 6082-T6 for optimization of penetration, cord width and reinforcement
por: Pascoal, Arlindo
Publicado em: (2018)
por: Pascoal, Arlindo
Publicado em: (2018)
article Thermal diffusivity measurements of vapour grown carbon fibre composites, using the optical beam deflection technique
por: Macedo, F. J.
Publicado em: (1999)
por: Macedo, F. J.
Publicado em: (1999)
article Assessment of the effectiveness of the NSM shear strengthening technique for deep T cross section RC beams
por: Barros, Joaquim A. O.
Publicado em: (2013)
por: Barros, Joaquim A. O.
Publicado em: (2013)
article Post-accident damage identification based on vibration measurements applied to masonry structures
por: Ramos, Luís F.
Publicado em: (2008)
por: Ramos, Luís F.
Publicado em: (2008)
article Damage localisation in beams using the ritz method and speckle shear interferometry
por: Santos, J.V. Araújo
Publicado em: (2010)
por: Santos, J.V. Araújo
Publicado em: (2010)
groups Damage localisation in beams using the ritz method and speckle shear interferometry
por: Santos, J.V. Araújo
Publicado em: (2010)
por: Santos, J.V. Araújo
Publicado em: (2010)
book Simulation strategies for dynamic and static behaviour of composite beams
por: Alves, Alexandra Manuela Vieira Cruz Pinto
Publicado em: (2023)
por: Alves, Alexandra Manuela Vieira Cruz Pinto
Publicado em: (2023)
article NSM shear strengthening technique with CFRP laminates applied in high T cross section RC beams
por: Dias, Salvador J. E.
Publicado em: (2017)
por: Dias, Salvador J. E.
Publicado em: (2017)
article Experimental and numerical studies on the shared activation anchoring of NSMR CFRP applied to RC beams
por: Schmidt, Jacob
Publicado em: (2019)
por: Schmidt, Jacob
Publicado em: (2019)
Registos relacionados
-
article Comparative study of vibration measuring techniques applied to aluminum beams localized damage
por: Silva, Edson Vinicius Garcia
Publicado em: (2019) -
article On the thermodynamics of aluminum cladding oxidation: water as the catalyst for spontaneous combustion
por: Maguire, John F.
Publicado em: (2022) -
article Vibration damping and acoustic behavior of PU-filled non-stochastic aluminum cellular solids
por: Carneiro, Vítor Hugo Pimenta
Publicado em: (2021) -
article Ultrasonic vibration as a primary mixing tool in accelerating aluminum–copper alloys preparation from their pure elements
por: Muhrat, Abdulsalam
Publicado em: (2019) -
article Aluminum recovery from water treatment sludges
por: Boaventura, Rui A. Rocha
Publicado em: (2000)