Publicação
Properties of tungsten mine waste geopolymeric binder
| Resumo: | Tungsten mine waste mud (TMWM) geopolymeric binder is a new cementitious material with a very high early age strength. It is obtained from dehydroxylated mine waste powder mix with minor quantities of calcium hydroxide and activated with NaOH and water-glass solutions. Tests on properties of TMWM binders such as workability, setting time, unrestrained shrinkage, water absorption and static modulus of elasticity were carried out and the results are reported in this paper. This is followed by comparisons with literature related data and a discussion about it. The results showed that current devices use to assess OPC fresh properties are not recommended to evaluate TMWM binders. It has also been found that traditional procedures used to evaluate unrestrained shrinkage may be responsible for misleading results when using those new binders. Water absorption data shows that TMWM has a very compacted structure. Results concerning the static modulus of elasticity are similar to the ones obtained by other authors. However the hypothesis related to modulus of elasticity decrease due to the use of high Al/Si alkali activated mixtures was not confirmed. |
|---|---|
| Autores principais: | Pacheco-Torgal, F. |
| Outros Autores: | Gomes, J. P. Castro; Jalali, Said |
| Assunto: | Geopolymeric binder Tungsten mine waste mud Workability Setting time Shrinkage Water absorption Static modulus of elasticity |
| Ano: | 2008 |
| País: | Portugal |
| Tipo de documento: | artigo |
| Tipo de acesso: | acesso aberto |
| Instituição associada: | Universidade do Minho |
| Idioma: | inglês |
| Origem: | RepositóriUM - Universidade do Minho |
Registos relacionados
article Tungsten mine waste geopolymeric binder versus ordinary portland cement based concrete: abrasion and acid resistance
por: Pacheco-Torgal, F.
Publicado em: (2007)
por: Pacheco-Torgal, F.
Publicado em: (2007)
article Investigations on mix design of tungsten mine waste geopolymeric binder
por: Pacheco-Torgal, F.
Publicado em: (2008)
por: Pacheco-Torgal, F.
Publicado em: (2008)
article Tungsten mine waste geopolymeric binder: preliminary hydration products investigations
por: Pacheco-Torgal, F.
Publicado em: (2009)
por: Pacheco-Torgal, F.
Publicado em: (2009)
article Bond strength between concrete substance and repair materials: comparisons between tungsten mine waste geopolymeric binder versus current commercial repair products.
por: Pacheco-Torgal, F.
Publicado em: (2006)
por: Pacheco-Torgal, F.
Publicado em: (2006)
article Investigations of tungsten mine waste geopolymeric binder: strength and microstructure
por: Pacheco-Torgal, F.
Publicado em: (2008)
por: Pacheco-Torgal, F.
Publicado em: (2008)
article Alkali-activated tungsten mine waste mud binder versus OPC concrete: acid and abrasion resistance
por: Pacheco-Torgal, F.
Publicado em: (2007)
por: Pacheco-Torgal, F.
Publicado em: (2007)
article Adhesion characterization of tungsten mine waste geopolymeric binder. Influence of OPC concrete substance surface treatment
por: Pacheco-Torgal, F.
Publicado em: (2008)
por: Pacheco-Torgal, F.
Publicado em: (2008)
article Shrinkage and mechanical performance of geopolymeric mortars based on calcined Tunisian clay
por: Tahri, W.
Publicado em: (2013)
por: Tahri, W.
Publicado em: (2013)
book Utilization of mining wastes to produce geopolymer binders
por: Pacheco-Torgal, F.
Publicado em: (2009)
por: Pacheco-Torgal, F.
Publicado em: (2009)
article Investigations about the effect of aggregates on strength and microstructure of geopolymeric mine waste mud binders
por: Pacheco-Torgal, F.
Publicado em: (2007)
por: Pacheco-Torgal, F.
Publicado em: (2007)
article Resistance to acid attack, abrasion and leaching behavior of alkali-activated mine waste binders
por: Pacheco-Torgal, F.
Publicado em: (2011)
por: Pacheco-Torgal, F.
Publicado em: (2011)
article Drying shrinkage of fly ash geopolymeric mortars reinforced with polymer hybrid fibres
por: Kheradmand, Mohammad
Publicado em: (2020)
por: Kheradmand, Mohammad
Publicado em: (2020)
article Effect of the calcinations temperatures of phosphate washing waste on the structural and mechanical properties of geopolymeric mortar
por: Dabbebi, R.
Publicado em: (2018)
por: Dabbebi, R.
Publicado em: (2018)
article Mechanical performance of geopolymeric mortars based on tunisian calcined clay, fly ash and metakaolin
por: Tahri, W.
Publicado em: (2015)
por: Tahri, W.
Publicado em: (2015)
article Structural properties of phosphate-washing waste based geopolymeric mortars
por: Dabbebi, R.
Publicado em: (2019)
por: Dabbebi, R.
Publicado em: (2019)
article Performance of waste based alkaline mortars submitted to accelerated carbon dioxide curing
por: Mastali, Mohammad
Publicado em: (2018)
por: Mastali, Mohammad
Publicado em: (2018)
book Geopolymeric repair mortars based on a low reactive clay
por: Tahri, Walid
Publicado em: (2018)
por: Tahri, Walid
Publicado em: (2018)
article Performance of mortars with commercially-available reactive magnesium oxide as alternative binder
por: Bravo, Miguel
Publicado em: (2021)
por: Bravo, Miguel
Publicado em: (2021)
article A structural experimental technique to characterize the viscoelastic behavior of concrete under restrained deformations
por: Faria, R.
Publicado em: (2017)
por: Faria, R.
Publicado em: (2017)
article Alkali-activated cement-based binder mortars containing phase change materials (PCMs): mechanical properties and cost analysis
por: Kheradmand, Mohammad
Publicado em: (2020)
por: Kheradmand, Mohammad
Publicado em: (2020)
article Shrinkage performance of fly ash alkali-activated cement based binder mortars
por: Kheradmand, Mohammad
Publicado em: (2018)
por: Kheradmand, Mohammad
Publicado em: (2018)
article Quantification of impact of lime on mechanical behaviour of lime cement blended mortars for bedding joints in masonry systems
por: Ramesh, Meera
Publicado em: (2019)
por: Ramesh, Meera
Publicado em: (2019)
article Mechanical performance of geopolymeric mortars based on tunisian calcined clay, fly ash and metakaolin
por: Tahri, W.
Publicado em: (2016)
por: Tahri, W.
Publicado em: (2016)
article Current and foreseen tungsten production in Portugal, and the need of safeguarding the access to relevant known resources
por: Mateus, António
Publicado em: (2021)
por: Mateus, António
Publicado em: (2021)
category Tungsten oxide nanoparticles prepared with soft templating methods
por: Coutinho, Paulo J. G.
Publicado em: (2009)
por: Coutinho, Paulo J. G.
Publicado em: (2009)
article Feasibility of using a lignin-containing waste in asphalt binders
por: Pérez, Ignacio
Publicado em: (2020)
por: Pérez, Ignacio
Publicado em: (2020)
article Concrete repair with geopolymeric mortars: influence of mortars composition on their workability and mechanical strength
por: Moura, D.
Publicado em: (2011)
por: Moura, D.
Publicado em: (2011)
article Current and Foreseen Tungsten Production in Portugal, and the Need of Safeguarding the Access to Relevant Known Resources
por: A., Mateus
Publicado em: (2021)
por: A., Mateus
Publicado em: (2021)
article Alkali activated geopolymeric binder using tungesten mine waste: preliminary investigation
por: Pacheco-Torgal, F.
Publicado em: (2005)
por: Pacheco-Torgal, F.
Publicado em: (2005)
article Alkali-activated binders produced from petrochemical fluid catalytic cracking catalyst waste
por: Costa, Carla
Publicado em: (2014)
por: Costa, Carla
Publicado em: (2014)
article Experimental study of the mechanical properties and shrinkage of self-compacting concrete with binary and ternary mixes of fly ash and limestone filler
por: Raposeiro Da Silva, Pedro
Publicado em: (2017)
por: Raposeiro Da Silva, Pedro
Publicado em: (2017)
article Strategies to mitigate shrinkage in an intermediate strength self-compacting concrete
por: Oliveira, M. J.
Publicado em: (2020)
por: Oliveira, M. J.
Publicado em: (2020)
article Plastic waste use as aggregate and binder modifier in open-graded asphalts
por: Costa, Liliana M. B.
Publicado em: (2015)
por: Costa, Liliana M. B.
Publicado em: (2015)
article Helium and deuterium irradiation effects in tungsten-based materials with titanium
por: Catarino, Norberto
Publicado em: (2018)
por: Catarino, Norberto
Publicado em: (2018)
article Use of phase change materials microcapsules in aerial lime and gypsum mortars
por: Cunha, Sandra Raquel Leite
Publicado em: (2012)
por: Cunha, Sandra Raquel Leite
Publicado em: (2012)
article Influence of adding encapsulated phase change materials in aerial lime based mortars
por: Cunha, Sandra Raquel Leite
Publicado em: (2013)
por: Cunha, Sandra Raquel Leite
Publicado em: (2013)
article Use of phase change materials microcapsules in aerial lime and gypsum mortars
por: Cunha, Sandra Raquel Leite
Publicado em: (2011)
por: Cunha, Sandra Raquel Leite
Publicado em: (2011)
category Waste mud characterization: a contribuition to quarries environmental impact mitigation and to a sustainable use of a natural resource
por: Gonçalves, Luís
Publicado em: (2004)
por: Gonçalves, Luís
Publicado em: (2004)
article Study of the interaction between asphalt and plastic wastes in new polymer modified binders (PMB)
por: Costa, Liliana M. B.
Publicado em: (2015)
por: Costa, Liliana M. B.
Publicado em: (2015)
article Alkali-activated binders: a review: part 2. About materials and binders manufacture
por: Pacheco-Torgal, F.
Publicado em: (2008)
por: Pacheco-Torgal, F.
Publicado em: (2008)
Registos relacionados
-
article Tungsten mine waste geopolymeric binder versus ordinary portland cement based concrete: abrasion and acid resistance
por: Pacheco-Torgal, F.
Publicado em: (2007) -
article Investigations on mix design of tungsten mine waste geopolymeric binder
por: Pacheco-Torgal, F.
Publicado em: (2008) -
article Tungsten mine waste geopolymeric binder: preliminary hydration products investigations
por: Pacheco-Torgal, F.
Publicado em: (2009) -
article Bond strength between concrete substance and repair materials: comparisons between tungsten mine waste geopolymeric binder versus current commercial repair products.
por: Pacheco-Torgal, F.
Publicado em: (2006) -
article Investigations of tungsten mine waste geopolymeric binder: strength and microstructure
por: Pacheco-Torgal, F.
Publicado em: (2008)