Publicação

Levofloxacin-loaded microneedles produced using 3D-printed molds for Klebsiella pneumoniae biofilm control

Ver documento

Detalhes bibliográficos
Resumo:Additive manufacturing advancements contribute considerably to several fields, and its use in the medical field is gaining attention due to its easily customizable option (patient-specific), low cost, and fast turnout time in developing drug delivery and diagnostic tools. Here, wereport the fabrication of a microneedle (MN) platform using a stereolithography 3D printer, varying the 3D printing angle and aspect ratio (2:1, 3:1, 4:1). The optimal printing angle was30, resulting in needle tip and base diameters of 50 µm and 330 µm, and heights of 550/850/1180 µm. Polyvinyl alcohol (PVA) MNs produced with varying levofloxacin concentrations showed variability of 4% in tip and 3% base diameters and 15% in height compared to the 3D-printed MNs. Geometry B wasused to produce levofloxacin-loaded PVA MNs and tested against Klebsiella pneumoniae colony biofilms. Levofloxacin wasreleased gradually, as assessed by spectrofluorimetry. The MIC of levofloxacin against the K. pneumoniae clinical isolate was4 µg/mL, but this concentration wasinsufficient to cause any effect on K. pneumoniae biofilms. Only concentrations 32 µg/mL werestatistically different compared to the unloaded MNs. 3D printing is an attractive solution to produce molds for fabricating biopolymeric MNs for topical drug delivery.
Autores principais:Vinayakumar, K. B.
Outros Autores:Silva, Maria Daniela; Martins, Artur; Mundy, Stephen; González-Losada, Pedro; Sillankorva, Sanna M.
Assunto:3D printing biofilms Klebsiella pneumoniae levofloxacin microneedles polyvinyl alcohol
Ano:2023
País:Portugal
Tipo de documento:artigo
Tipo de acesso:acesso aberto
Instituição associada:Universidade do Minho
Idioma:inglês
Origem:RepositóriUM - Universidade do Minho

Registos relacionados

Registos relacionados