Publicação
Characterization of magnetron sputtered sub-stoichiometric CrAlSiNx and CrAlSiOyNx coatings
| Resumo: | The influence of varying nitrogen and oxygen partial pressures on microstructure, mechanical and optical properties of magnetron sputtered CrAlSiNx and CrAlSiOyNx coatings has been studied. The partial pressure of nitrogen reactive gaswas varied from0.037 Pa to 0.15 Pa for CrAlSiNx films, and the N2/O2 (85%:15%) partial pressure was varied from 0.046 Pa to 0.21 Pa for CrAlSiOyNx layers. Transmittance and reflectance of samples were measured and were modeled to obtain the spectral optical constants, n and k. Chemical state, composition, morphology and microstructure of films were analyzed by XPS, RBS, XRD, Raman Spectroscopy and SEM. Films' hardness was evaluated using nanoindentation method. XRD results revealed that the two samples CrAlSiNx with PN =0.15 Pa and CrAlSiOyNx with PNO = 0.21 Pa are polycrystalline with cubic (fcc-B1) structure. On contrary, all other films prepared with lower reactive gases partial pressures are amorphous. The chemical composition changed with the variation of reactive gases partial pressure, although the Cr: Al: Si composition ratio remained approximately constant, 1.25:1.5:1. All samples showed low hardness, mainly due to lower content of reactive gases and higher content of Si. However, the sample CrAlSiNx with PN = 0.15 Pa has the highest value of 11.1 GPa. Optical constants are seen to be very sensitive to reactive gases partial pressure. The refractive index and extinction coefficient were lower for coatings with higher reactive gases partial pressure. These coatings are good candidates for designing selective solar absorber stacks for different applications. |
|---|---|
| Autores principais: | Al-Rjoub, A. |
| Outros Autores: | Costa, P.; Rebouta, L.; Cerqueira, M. F.; Alpuim, P.; Barradas, N. P.; Alves, E. |
| Assunto: | CrAlSiNx Optical properties CrAlSiOyNx Chemical structure Hardness CrAlSiO N y x |
| Ano: | 2017 |
| País: | Portugal |
| Tipo de documento: | artigo |
| Tipo de acesso: | acesso aberto |
| Instituição associada: | Universidade do Minho |
| Idioma: | inglês |
| Origem: | RepositóriUM - Universidade do Minho |
Registos relacionados
article CrAlSiN barrier layer to improve the thermal stability of W/CrAlSiNx/ CrAlSiOyNx/SiAlOx solar thermal absorber
por: Al-Rjoub, A.
Publicado em: (2019)
por: Al-Rjoub, A.
Publicado em: (2019)
article A study of solar thermal absorber stack based on CrAlSiNx /CrAlSiNxOy structure by ion beams
por: Al-Rjoub, A.
Publicado em: (2019)
por: Al-Rjoub, A.
Publicado em: (2019)
article A design of selective solar absorber for high temperature applications
por: Al-Rjoub, A.
Publicado em: (2018)
por: Al-Rjoub, A.
Publicado em: (2018)
article W/AlSiTiNx/SiAlTiOyNx/SiAlOx multilayered solar thermal selective absorber coating
por: AL-Rjoub, A.
Publicado em: (2020)
por: AL-Rjoub, A.
Publicado em: (2020)
article Multi-layer solar selective absorber coatings based on W/WSiAlNx /WSiAlOyNx/SiAlOx for high temperature applications
por: Al-Rjoub, A.
Publicado em: (2018)
por: Al-Rjoub, A.
Publicado em: (2018)
image Electrical and optical properties of AlNxOy thin films deposited by reactive DC magnetron sputtering
por: Borges, Joel Nuno Pinto
Publicado em: (2012)
por: Borges, Joel Nuno Pinto
Publicado em: (2012)
image Effects of annealing on the electrical and optical properties of AlNxOy thin films
por: Borges, Joel Nuno Pinto
Publicado em: (2012)
por: Borges, Joel Nuno Pinto
Publicado em: (2012)
article Influence of stoichiometry and structure on the optical properties of AlNxOy films
por: Borges, Joel Nuno Pinto
Publicado em: (2013)
por: Borges, Joel Nuno Pinto
Publicado em: (2013)
article Solar selective absorbing coatings based on AlSiN/AlSiON/AlSiOy layers
por: Rebouta, L.
Publicado em: (2015)
por: Rebouta, L.
Publicado em: (2015)
article Influência da incorporação de partículas de SiC na microestrutura e no comportamento tribológico de compósitos Al/SiCp com gradiente funcional
por: Vieira, A. C.
Publicado em: (2007)
por: Vieira, A. C.
Publicado em: (2007)
article Solar selective absorbers based on Al2O3:W cermets and AlSiN/AlSiON layers
por: Rebouta, L.
Publicado em: (2015)
por: Rebouta, L.
Publicado em: (2015)
article Elastic properties of (Ti,Al,Si) N nanocomposite films
por: Carvalho, S.
Publicado em: (2001)
por: Carvalho, S.
Publicado em: (2001)
article Tribocorrosion behaviour of hot pressed CoCrMo−Al2O3 composites for biomedical applications
por: Doni, Z.
Publicado em: (2014)
por: Doni, Z.
Publicado em: (2014)
article Effect of thermal treatments on the structure of MoNxOy thin films
por: Cunha, L.
Publicado em: (2008)
por: Cunha, L.
Publicado em: (2008)
article The effect of increasing Si content in the absorber layers (CrAlSiNx /CrAlSiOyNx) of solar selective absorbers upon their selectivity and thermal stability
por: Al-Rjoub, A.
Publicado em: (2019)
por: Al-Rjoub, A.
Publicado em: (2019)
category Estudos de molhabilidade em compósitos de Al reforçados com partículas de SiC
por: Vieira, A. C.
Publicado em: (2005)
por: Vieira, A. C.
Publicado em: (2005)
article Dry sliding and tribocorrosion behaviour of hot pressed CoCrMo biomedical alloy as compared with the cast CoCrMo and Ti6Al4V alloys
por: Doni, Z.
Publicado em: (2013)
por: Doni, Z.
Publicado em: (2013)
article Effect of the microstructure on the cutting performance of superhard (Ti, Si, Al)N nanocomposite films
por: Fernandes, C.
Publicado em: (2008)
por: Fernandes, C.
Publicado em: (2008)
image Optical emission spectroscopy study of a DC magnetron discharge in Ar/(O2-N2)
por: Borges, Joel Nuno Pinto
Publicado em: (2012)
por: Borges, Joel Nuno Pinto
Publicado em: (2012)
article Characterization of TiAlSiN/TiAlSiON/SiO2 optical stack designed by modelling calculations for solar selective applications
por: Rebouta, L.
Publicado em: (2012)
por: Rebouta, L.
Publicado em: (2012)
category Effect of silicon carbide particles on the microstructure and tribological behaviour of functional graded Al/SiCp composites
por: Vieira, A. C.
Publicado em: (2006)
por: Vieira, A. C.
Publicado em: (2006)
article Characteristics of silicon doped chromium nitride coatings produced by magnetron sputtering : the influence of processing parameters
por: Cunha, L.
Publicado em: (2011)
por: Cunha, L.
Publicado em: (2011)
article Impact of the ultrasonic-assisted casting of an AlSi7Mg alloy on T6 heat treatment
por: Gomes, Inês V.
Publicado em: (2023)
por: Gomes, Inês V.
Publicado em: (2023)
article Optical and structural analysis of solar selective absorbing coatings based on AlSiOx:W cermets
por: Dias, D.
Publicado em: (2017)
por: Dias, D.
Publicado em: (2017)
article Structural evolution of Ti-Al-Si-N nanocomposite coating
por: Carvalho, S.
Publicado em: (2009)
por: Carvalho, S.
Publicado em: (2009)
article Effect of Al2Cu precipitates size and mass transport on the polarisation behaviour of age-hardened Al–Si–Cu–Mg alloys in 0.05M NaCl
por: Vieira, A. C.
Publicado em: (2011)
por: Vieira, A. C.
Publicado em: (2011)
article Improvement on sliding wear behavior of Al/Cast iron tribopair by CNT’s reinforcement of an Al alloy
por: Carvalho, Óscar Samuel Novais
Publicado em: (2015)
por: Carvalho, Óscar Samuel Novais
Publicado em: (2015)
article Microstructure and mechanical properties of nanocomposite (Ti,Si,Al)N coatings
por: Carvalho, S.
Publicado em: (2001)
por: Carvalho, S.
Publicado em: (2001)
article Effects of ion bombardment on properties of d.c. sputtered superhard (Ti, Si, Al)N nanocomposite coatings
por: Ribeiro, E.
Publicado em: (2002)
por: Ribeiro, E.
Publicado em: (2002)
school Estudo do comportamento ao desgaste de compósitos de Al-12Si/NbC desenvolvidos por deposição assistida por laser
por: Lopes, Miguel
Publicado em: (2018)
por: Lopes, Miguel
Publicado em: (2018)
article Laser surface texturing and numerical simulation of heat flux on Cr2AlC MAX phase heat exchangers
por: Mesquita-Guimarães, J.
Publicado em: (2023)
por: Mesquita-Guimarães, J.
Publicado em: (2023)
school Desenvolvimento de revestimentos de diamante CVD/TiAlSiN para aplicações na indústria aeronáutica
por: Neves, Rui Filipe da Silva
Publicado em: (2021)
por: Neves, Rui Filipe da Silva
Publicado em: (2021)
image Characterization of Al2O3 and SiO2 ultra thin-films deposited by ALD for microfabricated rubidium vapor cells
por: Cunha, Florival Moura
Publicado em: (2022)
por: Cunha, Florival Moura
Publicado em: (2022)
school Preparação pelo processo "sol-gel" e caracterização de materiais dos sistemas SiO2-ZrO2, SiO2-TiO2 e SiO2-Al2O3. Aplicação como revestimentos protectores
por: Salvado, Isabel
Publicado em: (1990)
por: Salvado, Isabel
Publicado em: (1990)
book Exposição do ano da ESAD.CR 2025 – Não Faço *
por: Ribeiro, Luís Miguel Macedo
Publicado em: (2025)
por: Ribeiro, Luís Miguel Macedo
Publicado em: (2025)
article Iron oxidation state effect on the Mg-Al- Si-O glassy system
por: Ferreira, N.M.
Publicado em: (2019)
por: Ferreira, N.M.
Publicado em: (2019)
article Influence of Al/Si atomic ratio on optical and electrical properties of magnetron sputtered Al1-xSixOy coatings
por: Costa, Pedro Miguel Pinto
Publicado em: (2019)
por: Costa, Pedro Miguel Pinto
Publicado em: (2019)
school Caracterização mecânica da liga AlSi10Mg obtida por SLM para aplicação em componentes automóveis
por: Santos, David Mendes dos
Publicado em: (2014)
por: Santos, David Mendes dos
Publicado em: (2014)
school Desenvolvimento de composições à base de Si₃N₄ para maquinagem de ligas da indústria aeronáutica
por: Ferreira, João José Pedrosa
Publicado em: (2025)
por: Ferreira, João José Pedrosa
Publicado em: (2025)
book From hermitean clifford analysis to subelliptic dirac operators on odd dimensional spheres and other CR manifolds
por: Cerejeiras, P.
Publicado em: (2018)
por: Cerejeiras, P.
Publicado em: (2018)
Registos relacionados
-
article CrAlSiN barrier layer to improve the thermal stability of W/CrAlSiNx/ CrAlSiOyNx/SiAlOx solar thermal absorber
por: Al-Rjoub, A.
Publicado em: (2019) -
article A study of solar thermal absorber stack based on CrAlSiNx /CrAlSiNxOy structure by ion beams
por: Al-Rjoub, A.
Publicado em: (2019) -
article A design of selective solar absorber for high temperature applications
por: Al-Rjoub, A.
Publicado em: (2018) -
article W/AlSiTiNx/SiAlTiOyNx/SiAlOx multilayered solar thermal selective absorber coating
por: AL-Rjoub, A.
Publicado em: (2020) -
article Multi-layer solar selective absorber coatings based on W/WSiAlNx /WSiAlOyNx/SiAlOx for high temperature applications
por: Al-Rjoub, A.
Publicado em: (2018)