Publicação
Experimental and analytical assessment of the capacity of traditional single notch joints and impact of retrofitting by self-tapping screws
| Resumo: | The joints are the most crucial parts of a timber building and determine the overall structural behaviour, load-bearing capacity and failure mechanisms. Therefore, keeping the joints fully functional is of utmost importance to ensure a desired structural performance of timber buildings under various actions. Since replacement of damaged parts of an existing structure is expensive and in many cases very difficult to perform in situ, retrofitting to avoid failure becomes an increasingly widespread strategy. In this paper, the capacity and failure mechanisms of single notch joints before and after a simple retrofitting intervention by means of self-tapping screws were investigated. To this end, a series of tests were carried out during the 5th COST FP 1101 Training School, held in University of Minho, Portugal. The joints were first tested under compression, and the load-bearing capacity values obtained at the end of tests were compared to the capacity values calculated using theoretical models proposed in a variety of national codes. Then, tested joints were retrofitted using self-tapping screws. The retrofitting strategy aimed to prevent failure mechanism that was shown to dominate joints' behaviour in the unreinforced state, rather than to increase the load-bearing capacity or stiffness. The impact of retrofitting on the joints' performance was discussed and the success of the proposed intervention was further debated. |
|---|---|
| Autores principais: | Sobra, Karel |
| Outros Autores: | de Rijk, Richard; Aktas, Yasemin D.; Avez, Coralie; Burawska, Isabela; Branco, Jorge M. |
| Assunto: | Traditional carpentry joints Single notch joints Retrofitting Self-tapping screws |
| Ano: | 2016 |
| País: | Portugal |
| Tipo de documento: | comunicação em conferência |
| Tipo de acesso: | acesso aberto |
| Instituição associada: | Universidade do Minho |
| Idioma: | inglês |
| Origem: | RepositóriUM - Universidade do Minho |
Registos relacionados
article Experimentations on the retrofitting of damaged Single Step Joints with Self-Tapping Screws
por: Verbist, Maxime Paul Augustin
Publicado em: (2018)
por: Verbist, Maxime Paul Augustin
Publicado em: (2018)
article Influence of the wood mechanical properties in the dovetail joint behavior
por: Sobra, Karel
Publicado em: (2015)
por: Sobra, Karel
Publicado em: (2015)
article Performance evaluation of traditional timber joints under cyclic loading and their influence on the seismic response of timber frame structures
por: Poletti, Elisa
Publicado em: (2016)
por: Poletti, Elisa
Publicado em: (2016)
article Single Step Joint: overview of European standardized approaches and experimentations
por: Verbist, Maxime
Publicado em: (2017)
por: Verbist, Maxime
Publicado em: (2017)
article Single step joint: overview of European standardized approaches and experimentations
por: Verbist, Maxime P.
Publicado em: (2016)
por: Verbist, Maxime P.
Publicado em: (2016)
article Analysis and strengthening of carpentry joints
por: Branco, Jorge M.
Publicado em: (2015)
por: Branco, Jorge M.
Publicado em: (2015)
article Load-bearing capacity of traditional dovetail carpentry joints with and without dowels: comparison of experimental and analytical results
por: Sobra, Karel
Publicado em: (2016)
por: Sobra, Karel
Publicado em: (2016)
article Comparison between experimental results and design equations of artificially degraded single step joints
por: Lima, Daniel F.
Publicado em: (2023)
por: Lima, Daniel F.
Publicado em: (2023)
article Design of three step joint typologies: review of european standardized approaches
por: Branco, Jorge M.
Publicado em: (2018)
por: Branco, Jorge M.
Publicado em: (2018)
article Application of the component method to traditional dovetail joints of timber trusses
por: Sobra, Karel
Publicado em: (2014)
por: Sobra, Karel
Publicado em: (2014)
article Mechanical characterization of traditional timber connections: experimental results
por: Poletti, Elisa
Publicado em: (2014)
por: Poletti, Elisa
Publicado em: (2014)
assignment Seismic strengthening of beam-column joints with multi-directional CFRP laminates
por: Coelho, Mário Rui Freitas
Publicado em: (2011)
por: Coelho, Mário Rui Freitas
Publicado em: (2011)
article The plasticating sequence In barrier extrusion screws part II: Experimental assessment
por: Gaspar-Cunha, A.
Publicado em: (2014)
por: Gaspar-Cunha, A.
Publicado em: (2014)
article Guidelines for on-site assessment of historic timber structures
por: Cruz, Helena
Publicado em: (2015)
por: Cruz, Helena
Publicado em: (2015)
article Effect of surface treatment on adhesively bonded aluminium-aluminium joints regarding aeronautical structures
por: Correia, Sérgio
Publicado em: (2018)
por: Correia, Sérgio
Publicado em: (2018)
article The influence of pellet-barrel friction on the granular transport in a single screw extruder
por: Michelangelli, O. P.
Publicado em: (2014)
por: Michelangelli, O. P.
Publicado em: (2014)
article The influences of moisture content variation, number and width of gaps on the withdrawal resistance of self tapping screws inserted in cross laminated timber
por: Silva, Catarina V.
Publicado em: (2016)
por: Silva, Catarina V.
Publicado em: (2016)
article Seismic retrofit of RC beam-column joints using the MF-EBR strengthening technique
por: Coelho, Mário Rui Freitas
Publicado em: (2012)
por: Coelho, Mário Rui Freitas
Publicado em: (2012)
book Reinforcement of traditional timber frame walls
por: Poletti, Elisa
Publicado em: (2021)
por: Poletti, Elisa
Publicado em: (2021)
article Modelling spherical joints in multibody systems
por: Silva, Mariana Isabel Santos Rodrigues
Publicado em: (2022)
por: Silva, Mariana Isabel Santos Rodrigues
Publicado em: (2022)
article Melting of PP/PA6 polymer blends in single screw extruders: an experimental study
por: Cunha, S. M.
Publicado em: (2008)
por: Cunha, S. M.
Publicado em: (2008)
article Melting of polymer blends in single-screw extrusion : an experimental study
por: Cunha, S. M.
Publicado em: (2009)
por: Cunha, S. M.
Publicado em: (2009)
category Melting of polymer blends in single-screw extrusion: an experimental study
por: Cunha, S. M.
Publicado em: (2009)
por: Cunha, S. M.
Publicado em: (2009)
article Reinforced dowel type connections: mechanical behaviour under cyclic tests
por: Rodrigues, Leonardo Filipe Guilherme
Publicado em: (2021)
por: Rodrigues, Leonardo Filipe Guilherme
Publicado em: (2021)
book Proposal of a CLT reinforcement of old timber floors
por: Roensmaens, Bertrand
Publicado em: (2019)
por: Roensmaens, Bertrand
Publicado em: (2019)
article An improved methodology to restrict the range of motion of mechanical joints
por: Silva, Mariana Rodrigues da
Publicado em: (2024)
por: Silva, Mariana Rodrigues da
Publicado em: (2024)
category Melting of immiscible physical and compatibilized polymer blends in single screw extruders
por: Cunha, S. M.
Publicado em: (2009)
por: Cunha, S. M.
Publicado em: (2009)
article A methodology to restrict the range of motion of joints: Application to the ankle joint complex
por: Silva, Mariana Isabel Santos Rodrigues
Publicado em: (2024)
por: Silva, Mariana Isabel Santos Rodrigues
Publicado em: (2024)
article Dynamics of multibody systems with spherical clearance joints
por: Flores, Paulo
Publicado em: (2005)
por: Flores, Paulo
Publicado em: (2005)
article Behaviour of a dovetail joint solved using force analyses
por: Sobra, K
Publicado em: (2015)
por: Sobra, K
Publicado em: (2015)
article A role for total alloplastic temporomandibular joint replacement in Gardner syndrome
por: Ângelo, David
Publicado em: (2024)
por: Ângelo, David
Publicado em: (2024)
article A comparison of spherical joint models in the dynamic analysis of rigid mechanical systems: ideal, dry, hydrodynamic and bushing approaches
por: Silva, Mariana Rodrigues da
Publicado em: (2022)
por: Silva, Mariana Rodrigues da
Publicado em: (2022)
article Modelling of timber joints in traditional structures
por: Branco, Jorge M.
Publicado em: (2006)
por: Branco, Jorge M.
Publicado em: (2006)
school Patient experience and satisfaction with different temporomandibular joint treatments
por: Rodrigues, Ana Lúcia Pereira
Publicado em: (2022)
por: Rodrigues, Ana Lúcia Pereira
Publicado em: (2022)
article Laboratory modular instrumented single screw extruder for optimisation of polymer processing
por: Gaspar-Cunha, A.
Publicado em: (2012)
por: Gaspar-Cunha, A.
Publicado em: (2012)
article Synovial entrapment in alloplastic temporomandibular joint replacement
por: Ângelo, David
Publicado em: (2021)
por: Ângelo, David
Publicado em: (2021)
article A preliminary analysis of the wear pathways of sliding contacts on temporomandibular joint total joint replacement prostheses
por: Pinto-Borges, Henrique
Publicado em: (2021)
por: Pinto-Borges, Henrique
Publicado em: (2021)
article Characterisation of mortarless refractory masonry joints under elevated temperatures
por: Gajjar, Pratik Naresh
Publicado em: (2023)
por: Gajjar, Pratik Naresh
Publicado em: (2023)
article Influence of the hip joint modeling approaches on the kinematics of human gait
por: Costa, João P. Morais
Publicado em: (2016)
por: Costa, João P. Morais
Publicado em: (2016)
article Statistical dependence investigation related to Dowel-Type timber joints
por: Aquino, Caroline D.
Publicado em: (2021)
por: Aquino, Caroline D.
Publicado em: (2021)
Registos relacionados
-
article Experimentations on the retrofitting of damaged Single Step Joints with Self-Tapping Screws
por: Verbist, Maxime Paul Augustin
Publicado em: (2018) -
article Influence of the wood mechanical properties in the dovetail joint behavior
por: Sobra, Karel
Publicado em: (2015) -
article Performance evaluation of traditional timber joints under cyclic loading and their influence on the seismic response of timber frame structures
por: Poletti, Elisa
Publicado em: (2016) -
article Single Step Joint: overview of European standardized approaches and experimentations
por: Verbist, Maxime
Publicado em: (2017) -
article Single step joint: overview of European standardized approaches and experimentations
por: Verbist, Maxime P.
Publicado em: (2016)